Skip to main content

Refrigerant Services in Apex, NC

$49 diagnostic. EPA-certified refrigerant handling. Same-day service in Apex, Cary & the Triangle.

Call 919-926-1475
Same-Day Service
Licensed & Insured
100% Satisfaction

Why Is My AC Blowing Warm Air?

The most common reason your AC blows warm air is low refrigerant. Refrigerant is the chemical that absorbs heat from inside your home and releases it outside. When levels drop, the system can't transfer heat effectively, and you get lukewarm air from the vents even though the system is running full blast. But low refrigerant is a symptom, not the actual problem. The real problem is a leak somewhere in the system, and until that leak is found and repaired, recharging is just a temporary fix.

There are other causes of warm air — a failed compressor, a bad capacitor, a tripped breaker, a stuck reversing valve — but refrigerant issues account for the majority of "my AC isn't cooling" calls we get across Apex, Cary, and the rest of the Triangle.

How Refrigerant Works (The Short Version)

Your AC doesn't create cold air. It moves heat. Refrigerant circulates between the indoor evaporator coil and the outdoor condenser coil, absorbing heat inside and dumping it outside. When the system has the right amount of refrigerant (called the charge), this cycle works efficiently. When it's low, the system struggles. When it's significantly low, the evaporator coil can freeze, the compressor can overheat, and you're looking at a breakdown.

AC systems are sealed. Refrigerant doesn't get "used up" like gasoline. If your levels are low, it's because refrigerant is leaking out somewhere. Common leak points include brazed joints at the evaporator and condenser coils, service valve connections, and the refrigerant line set running between your indoor and outdoor units.

The R-22 Problem for Triangle Homeowners

If your AC was installed before 2010, there's a good chance it uses R-22 Freon. R-22 production was banned in the United States because it damages the ozone layer. The remaining supply is recycled or reclaimed, and the price reflects the scarcity.

Here's what that means in real dollars. R-22 recharges now run $150 to $300 per pound, depending on supply. A typical system might need 3 to 7 pounds to go from low to full. That's $450 to $2,100 for a recharge that may only last a few months if the leak isn't repaired.

By comparison, R-410A (the current standard refrigerant) costs $50 to $80 per pound. Many Apex and Cary homes built in the early 2000s still run R-22 systems that are now 20-plus years old. At some point, the cost of repeatedly recharging R-22 exceeds the cost of replacing the system with one that uses R-410A.

We help homeowners do that math honestly. Sometimes one more R-22 recharge plus a leak repair buys you another two to three years while you plan for replacement. Sometimes the numbers say replace now. We give you both options with real prices and let you decide.

R-410A and Newer Refrigerants

R-410A has been the standard since 2010 and operates at higher pressures, which means the system components are built differently than R-22 systems. You can't just swap R-410A into an R-22 system — the compressor, coils, and line set aren't rated for it.

Starting in 2025, new systems are transitioning to R-454B (also called Puron Advance), which has a lower global warming potential than R-410A. If you're replacing your system now, ask us about equipment that uses the newest refrigerants. It future-proofs your investment.

Our Refrigerant Service Process

Our $49 diagnostic starts with measuring your system's pressures to determine the current refrigerant charge. If it's low, we move to leak detection.

Finding refrigerant leaks requires methodical work. We use electronic leak detectors, UV dye testing, and visual inspection to locate the source. Some leaks are obvious — a corroded coil connection or a damaged line set. Others are tiny pinhole leaks that take careful detective work.

Once we find the leak, we explain your options:

Repair the leak and recharge. For newer systems with small, accessible leaks, this is usually the right call. Repair the joint, pull a vacuum to remove moisture and contaminants, recharge to manufacturer specifications, and verify operation.

Replace the leaking component. If the evaporator or condenser coil has corroded to the point of multiple leaks, replacing the coil is more reliable than patching it.

Replace the system. If you're running R-22, the system is 15-plus years old, and the leak is in an expensive component, replacement often makes more financial sense.

All refrigerant work must be performed by EPA-certified technicians. Venting refrigerant is a federal violation with serious fines. Our techs are EPA Section 608 certified and handle every refrigerant type properly — recovery, recycling, and disposal all follow federal regulations.

Same-Day Service Across the Triangle

Warm air in a Triangle summer isn't something you can ignore for a week. We offer same-day refrigerant diagnostics and repairs across Apex, Cary, Holly Springs, Fuquay-Varina, Raleigh, and Durham. Element Service Group is veteran-owned with over 700 five-star reviews, and our trucks carry the equipment and refrigerant to handle most jobs in a single visit.

Problems We Fix

Our experts can diagnose and resolve any issue

Slow Refrigerant Leak

Gradual refrigerant loss causes your system to work harder, cool less effectively, and consume more energy over time. Many Apex homeowners notice slowly declining performance before realizing refrigerant is the culprit.

System Not Cooling Adequately

Low refrigerant is the most common cause of an AC that runs constantly but can't reach the set temperature—especially critical during Triangle area summers when outdoor temperatures exceed 90 degrees regularly.

Frozen Evaporator Coil

When refrigerant levels drop too low, the evaporator coil temperature falls below freezing, causing ice buildup that blocks airflow entirely. This can lead to water damage when the ice melts and compressor failure if not addressed.

R-22 Phase-Out Challenges

Older systems using R-22 (Freon) face escalating costs as this refrigerant has been phased out under EPA regulations. If your R-22 system develops a leak, converting to R-410A or replacing the system may be more economical than repeated recharges.

Why Choose Element Service Group for Refrigerant Services

We're your trusted partner for all Refrigerant Services needs

Professional Refrigerant Services technician at work

EPA-Certified Technicians

All our HVAC technicians hold EPA Section 608 Universal certification for refrigerant handling. We follow strict environmental compliance procedures for recovery, recycling, and disposal of all refrigerants.

Find the Leak First

We never simply top off refrigerant without identifying the source of the loss. Adding refrigerant to a leaking system wastes money and delays the inevitable. We find and fix the leak for a lasting solution.

Precision Charging

Proper refrigerant charge is critical—both undercharging and overcharging reduce efficiency and can damage your compressor. We use superheat and subcooling measurements to achieve manufacturer-exact specifications.

Honest R-22 Guidance

If your older system uses R-22, we provide straightforward cost comparisons between repair, refrigerant conversion, and system replacement so you can make an informed decision that makes financial sense for your situation.

Frequently Asked Questions About Refrigerant Services

Get answers to common questions about our refrigerant services services

How do I know if my AC is low on refrigerant?

Common signs include: warm air from vents, system running constantly without reaching set temperature, ice on the refrigerant lines or evaporator coil, and higher than normal electricity bills. If you notice these symptoms during NC summer, call for a diagnosis promptly.

Why does refrigerant get low?

Unlike fuel, refrigerant doesn't get consumed—it circulates in a sealed system. Low refrigerant always means there's a leak somewhere. Simply adding more without fixing the leak is a temporary fix that wastes money and harms the environment.

My system uses R-22—what are my options?

R-22 production has been banned since 2020, making remaining supplies increasingly expensive ($75-$150+ per pound). Your options include repairing and recharging (short-term), converting to an R-410A-compatible system, or replacing with a new high-efficiency unit. We help you evaluate the most cost-effective path.

How much does a refrigerant recharge cost?

Costs depend on refrigerant type and amount needed. R-410A recharges typically run $200-$500. R-22 recharges can cost $500-$1,500+ due to scarce supply. We always provide a complete diagnosis and quote before performing any work.