Refrigerant services start with the most common reason your AC blows warm air: low refrigerant. Refrigerant is the chemical that absorbs heat from inside your home and releases it outside. When levels drop, the system can't transfer heat effectively, and you get lukewarm air from the vents even though the system is running full blast. But low refrigerant is a symptom, not the actual problem. The real problem is a leak somewhere in the system, and until that leak is found and repaired, recharging is just a temporary fix.
There are other causes of warm air (a failed compressor, a bad capacitor, a tripped breaker, a stuck reversing valve), but refrigerant problems are one of the most common reasons behind a "my AC isn't cooling" call.
How Refrigerant Works (The Short Version)
Your AC doesn't create cold air. It moves heat. Refrigerant circulates between the indoor evaporator coil and the outdoor condenser coil, absorbing heat inside and dumping it outside. When the system has the right amount of refrigerant (called the charge), this cycle works efficiently. When it's low, the system struggles. When it's significantly low, the evaporator coil can freeze, the compressor can overheat, and you're looking at a breakdown.
AC systems are sealed. Refrigerant doesn't get "used up" like gasoline. If your levels are low, it's because refrigerant is leaking out somewhere. Common leak points include brazed joints at the evaporator and condenser coils, service valve connections, and the refrigerant line set running between your indoor and outdoor units.
The R-22 Problem for Triangle Homeowners
If your AC was installed before 2010, there's a good chance it uses R-22 Freon. R-22 production was banned in the United States because it damages the ozone layer. The remaining supply is recycled or reclaimed, and the price reflects the scarcity.
Here's what that means in real dollars. R-22 recharges now run $150 to $300 per pound, depending on supply. A typical system might need 3 to 7 pounds to go from low to full. That's $450 to $2,100 for a recharge that may only last a few months if the leak isn't repaired.
By comparison, R-410A (the refrigerant in most systems installed from about 2010 to 2024) costs $50 to $80 per pound. Many Apex and Cary homes built in the early 2000s still run R-22 systems that are now 20-plus years old. At some point, the cost of repeatedly recharging R-22 exceeds the cost of replacing the system.
We help homeowners do that math honestly. Sometimes one more R-22 recharge plus a leak repair buys you another two to three years while you plan for replacement. Sometimes the numbers say replace now. We give you both options with real prices and let you decide.
R-410A and Newer Refrigerants
R-410A replaced R-22 as the standard around 2010 and operates at higher pressures, which means the system components are built differently than R-22 systems. You can't just swap R-410A into an R-22 system: the compressor, coils, and other components aren't designed for it.
R-410A is now being phased down too. Under EPA rules, new residential systems built from 2025 on use lower global warming potential refrigerants, mostly R-454B or R-32. Existing R-410A systems can still be serviced and repaired. If you're replacing your system, ask us which refrigerant the new equipment uses and what that means for service down the road.
Our Refrigerant Service Process
Our $49 diagnostic for new customers starts with measuring your system's pressures to determine the current refrigerant charge. If it's low, we move to leak detection.
Finding refrigerant leaks requires methodical work. We use electronic leak detectors, UV dye testing, and visual inspection to locate the source. Some leaks are obvious: a corroded coil connection or a damaged line set. Others are tiny pinhole leaks that take careful detective work.
Once we find the leak, we explain your options:
Repair the leak and recharge. For newer systems with small, accessible leaks, this is usually the right call. Repair the joint, pull a vacuum to remove moisture and contaminants, recharge to manufacturer specifications, and verify operation.
Replace the leaking component. If the evaporator or condenser coil has corroded to the point of multiple leaks, replacing the coil is more reliable than patching it.
Replace the system. If you're running R-22, the system is 15-plus years old, and the leak is in an expensive component, replacement often makes more financial sense.
All refrigerant work must be performed by EPA-certified technicians. Venting refrigerant is a federal violation with serious fines. Our techs are EPA Section 608 certified and handle every refrigerant type properly: recovery, recycling, and disposal all follow federal regulations.
Same-Day Service Across the Triangle
Warm air in a Triangle summer isn't something you can ignore for a week. We offer same-day refrigerant diagnostics and repairs across Apex, Cary, Holly Springs, Fuquay-Varina, Raleigh, and Durham. Element Service Group is veteran-owned with over 900 five-star reviews, and our trucks carry the equipment and refrigerant to handle most jobs in a single visit.